Magenta MULTIVIEW XR2000 Guide d'installation

1 . MultiView XRTx Transmitter Quick Reference & Setup Guide Magenta Research 128 Litchfield Road, New Milford, CT 06776 USA (860) 2

10 MAGENTA MULTIVIEW™ SERIES Figure 3-4. Receiver connections on the AK600 232 3.3.4 CONNECTIONS ON THE VGA/AUDIO T4/T5 TRANSMITTERS The

11 . CHAPTER 3: Setup and Installation 3.3.5 CONNECTIONS ON THE SINGLE-PORT VGA SA and SAP The Single-Port MultiView™ CAT5 Video System SA/SAP series

12 MAGENTA MULTIVIEW™ SERIES 4. Troubleshooting 4.1. Common Problems In most cases, nearly every issue with the MultiView™ CAT5 Video System can be

13 . CHAPTER 4: Troubleshooting Problem: Serial communication doesn’t work correctly. Solution: • Are the serial devices con

14 MAGENTA MULTIVIEW™ SERIES Appendix A. Cabling Pinouts Table A-1. HD15 video connector. *SA audio channels a

15 . APPENDIX A: Cable Pinning Appendix A. Cabling Pinouts Table A-3. DB9 Female Serial connector Table A-4. T568B CAT5 pinout

16 MAGENTA MULTIVIEW™ SERIES Appendix B. Setting Sync Signal Output Termination In some cases, it may be necessary to disable the 75-ohm termination

17 . APPENDIX C: DC Restore Appendix C. DC Restore to fix Green Shift of AC Coupled Signals The standard MultiView product is designed to function wi

18 MAGENTA MULTIVIEW™ SERIES Appendix D. XRTx Configuration Settings Note: XRTx transmitters are typically pre-configured at time of order and will

19 . APPENDIX D: XRTX Configuration Settings Table D-1: MultiView XRTx Configuration Jumper Settings Configuration Option (all options utilize 4th pa

2 MAGENTA MULTIVIEW™ SERIES © 1998-2009 by Magenta Research All rights reserved. Magenta Research 128 Litchfield Road New Milford,

20 MAGENTA MULTIVIEW™ SERIES Appendix E. Serial Daughterboard (SDB) Settings The single-port serial transmitters and single-port and dual daisy chain

21 . APPENDIX D: Serial Settings Appendix E. Serial Daughterboard (SDB) Settings, cont Table D-2. Receiver SDB jumper settings

22 MAGENTA MULTIVIEW™ SERIES Appendix F. Rackmounting Units The Rackmount Kits include brackets for mounting a single transmitter, single receiver, o

23 . APPENDIX F: Pollable Serial Mode Appendix G. Pollable Serial Mode The SAP pollable serial daisychainable receivers with video, audio and RS232

24 MAGENTA MULTIVIEW™ SERIES Appendix G. Pollable Serial Mode Address Chart 22

25 . APPENDIX F: Pollable Serial Mode Appendix G. Pollable Serial Mode Address Chart (cont.) 23

26 MAGENTA MULTIVIEW™ SERIES 24 Appendix H. DDC Modes The MultiView XRTx features the ability to send DDC/EDID display identifiers to the video sourc

27 . 25 Appendix I. Setting Sync Mode The XRTx has the capability for fixed and agile sync. The default sync mode setting is for agile sync which r

28 MAGENTA MULTIVIEW™ SERIES Magenta Research 128 Litchfield Road, New Milford, CT 06776 USA (860) 210-0546 FAX (860) 210-1758

3 . 1 FEDERAL COMMUNICATIONS COMMISSION AND INDUSTRY CANADA RADIO FREQUENCY INTERFERENCE STATEMENTS This equipment generates, uses, and can radiate

4 MAGENTA MULTIVIEW™ SERIES Contents Chapter

5 . 1.Specifications Cable Required: Category 5, 5e, 6 shielded or unshielded twisted pair Compliance: CE; FCC Class A, IC Class/class A Video

6 MAGENTA MULTIVIEW™ SERIES 2. Introduction 2.1 Overview The Magenta MultiView™ Series extends VGA and video signals over ordinary Category 5 cable.

7 . CHAPTER 3: SETUP & INSTALLATION 3. Setup and Installation 3.1 Data Mode Configuration (RS232 and SA versions) XRTx 232 serial transmitters a

8 MAGENTA MULTIVIEW™ SERIES 4. Connect the CAT5 cable to the transmitter. 5. Apply power on the transmitter. The LED should light and, if there’s a

9 . CHAPTER 3: Setup and Installation Figure 3-2. Connections on the AK600 with audio. 3.3.3 CONNECTIONS ON THE SINGLE-PORT VGA/RS-232 Th