Magenta MULTIVIEW XR2000 Guide d'installation télécharger pdf (Page 8)

MAGENTA MULTIVIEW™ SERIES

4. Connect the CAT5 cable to the transmitter.

5. Apply power on the transmitter. The LED should light and, if there’s a local

monitor attached, a video image should appear on the monitor’s screen.

At the receiver end (refer to the appropriate receiver manual):

1. Connect the VIDEO OUTPUT HD15 connector to the display unit, and attach

any audio (AUX I/O) and/or serial connections (IOIO) depending on the model of

MultiView™ CAT5 Video System.

2. Connect the CAT5 cable to the LINK INPUT connection. If daisy chaining units,

connect the output CAT5 cable to the LINK OUTPUT connection.

3. Apply power. The LED should light and video should appear on the display

(make sure display is powered ON).

4. Adjust video levels and skew compensation per appropriate receiver manual.

3.3.2 CONNECTIONS ON THE SINGLE-PORT VGA/AUDIO

The single-port units with audio support video and audio signals over CAT5 cable. The

audio signal is line-level audio, and powered speakers are required. Note that there’s a

single connection for audio input. You can also use the transmitters and receivers to

make video-only connections without mono audio. Figure 3-1 shows the Single-Port

MultiView™ CAT5 Video System with Audio Transmitter connections, and Figure 3-2

shows the typical receiver connections.

Figure 3-1. Connections on the XRTx Universal Transmitter.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Pas de commentaire

Magenta MULTIVIEW XR2000 Guide d'installation Page 8